Investigating the Influence of Heavy Oil Recovery by In Situ Combustion during Air Injection as EOR Technique

Shaikh Azizullah

Abstract


Heavy oil is one of the most useful energy resource special in the times of crises when other resources are not present in profusion. However, Occurrence of heavy oil in unconsolidated sands is one the most challenging factor to recover the heavy oil. Therefore, in this study the main focus is derived towards the extraction of heavy oil with optimistic procedure called air injection. For the research, a reactor assembly was developed for the experimental work on air (21% oxygen) injection into heavy oil (12.59 °API) reservoir. Total 13 kinetics runs were conducted on unconsolidated cores by varying the parameters involved system pressure, flow rate (air flux), oxidation temperature (heat input), and rock formation (sand matrix). It was found that the process is very dependent on operating conditions employed, as oxygen consumption rate was very dependent on air flux. Increase of air flux from 15.19 to 22.78 m3/m2-hr resulted in slightly increasing rates of oxygen consumption over the temperature range under investigation. The temperature difference also shows great effect on the high temperature oxidation. The pressure and porous media also has great impact on the combustion behavior. The influence of individual parameter was obtained from analysis of the inlet oxygen and composition of flue gases from the combustion cell. Indeed, the oxygen conversion was too less to evaluate the kinetic data at temperature less than 250 °C while for oxidation reactions, the oxygen statistics analyzed from temperature above than 350 °C. The experimental results reveal that the average maximum peak temperature was 440 °C, and the oxidation reaction process at high temperature was very effective in terms of produced carbon oxides with an average percentage of 9.5% CO2, 5.5% CO in flue gases. Oil displacement was observed from the analysis of flue gases, consequently; incremental oil recovery was achieved between 56%-80% under high temperature oxidation (HTO) conditions.

Keywords


Air Injection; Enhanced Oil Recovery; Heavy Oil; High Temperature Oxidation; Oxidation Reaction

Full Text:

PDF

References


J. Barillas, T. D. Júnior, and W. Mata, "Improved oil recovery process for heavy oil: a review," Brazilian journal of Petroleum and gás, vol. 2, 2008.

V. Alvarado and E. Manrique, "Enhanced oil recovery: an update review," Energies, vol. 3, pp. 1529-1575, 2010.

Y. Wu, A. Mahmoudkhani, P. Watson, T. Fenderson, H. S. Kolla, and M. Nair, "A non-thermal surfactant-polymer based technology for enhanced heavy oil recovery in oil sand and ultra shallow reservoirs," in SPE Heavy Oil Conference Canada, 2012.

M. Ursenbach, R. Moore, and S. Mehta, "Air injection in heavy oil reservoirs-a process whose time has come (again)," Journal of Canadian Petroleum Technology, vol. 49, pp. 48-54, 2010.

L. Zhong, D. Yu, Y. Gong, P. Wang, L. Zhang, and C. Liu, "Feasibility Study of the In-Situ Combustion in Shallow, Thin, and Multi-Layered Heavy Oil Reservoir," in International Thermal Operations and Heavy Oil Symposium, 2008.

D. Gutierrez, F. Skoreyko, R. Moore, S. Mehta, and M. Ursenbach, "The challenge of predicting field performance of air injection projects based on laboratory and numerical modelling," Journal of Canadian Petroleum Technology, vol. 48, pp. 23-33, 2009.

A. H. Tunio, "To Investigate the Use of Air Injection to Improve Oil Recovery from Light Oil Reservoirs," MEHRAN UNIVERSITY OF ENGINEERING & TECHNOLOGY JAMSHORO, 2008.

H. Al-Saffar, D. Price, A. Soufi, and R. Hughes, "Distinguishing between overlapping low temperature and high temperature oxidation data obtained from a pressurised flow reactor system using consolidated core material," Fuel, vol. 79, pp. 723-732, 2000.

O. Cazarez-candia and J. Cruz-Hernandez, "Effect of pressure and air flow rate on in-situ combustion experiments of heavy oil," in SPE Latin America and Caribbean Petroleum Engineering Conference, 2012.

A. Mendoza, H. Perozo, D. A. Oliveros, and N. Reyes, "Study for Improving the In-Situ Combustion of Venezuela Extra-Heavy Crude Oil Using Unconventional Additive," in SPE Latin American and Caribbean Petroleum Engineering Conference, 2010.

A. M. Chicuta and O. V. Trevisan, "Experimental study on in-situ combustion of a Brazilian heavy oil," in Latin American and Caribbean Petroleum Engineering Conference, 2009.

M. Greaves, A. Wilson, M. Al-Honi, and A. Lockett, "Improved recovery of light/medium heavy oils in heterogeneous reservoirs using air injection/insitu combustion (ISC)," in SPE Western Regional Meeting, 1996.

D. Marjerrison and M. Fassihi, "A procedure for scaling heavy-oil combustion tube results to a field model," in SPE/DOE Enhanced Oil Recovery Symposium, 1992.

R. Prasad and J. Slater, "High-Pressure Combustion Tube Tests," in SPE Enhanced Oil Recovery Symposium, 1986.




DOI: http://dx.doi.org/10.36785/jaes.v10i1.375

Creative Commons License
Journal of Applied and Emerging Sciences by BUITEMS is licensed under a Creative Commons Attribution 4.0 International License.
Based on a work at www.buitms.edu.pk.
Permissions beyond the scope of this license may be available at http://journal.buitms.edu.pk/j/index.php/bj

Contacts | Feedback
© 2002-2014 BUITEMS